Operation - RT10
24
Connecting To Tractor
Always inspect the tractor’s hitch and equipment’s
hitch before connecting. See the tractor’s owner’s
manual.
Move the tractor into position in front of the
equipment.
WARNING
AVOID INJURY OR DEATH
Keep fingers and hands out of pinch points
when connecting and disconnecting
equipment.
WARNING
AVOID INJURY OR DEATH
Before moving the tractor, look in all directions
and make sure no bystanders, especially small
children are in the work area.
Do not allow anyone between the tractor
and the equipment when backing up to the
equipment for connecting.
Entering The Operator’s Position
Enter the operator’s position, start the engine, and
release the parking brake.
IMPORTANT
Follow the instructions in your tractor’s
operation manual for the correct procedure.
Leaving The Operator’s Position
Always perform the following steps when leaving
the operator’s position:
WARNING
AVOID INJURY OR DEATH
Before you leave the operator’s position:
• Always park on a flat level surface.
• Place all controls in NEUTRAL.
• Engage the park brake.
• Stop the engine and remove the key.
• Wait for all moving parts to stop.
To Next Page
Loading...
