Maintenance - RT10
44
Safety And Equipment Signs
Remove all portions of the damaged safety sign
(decal).
Thoroughly clean the area with glass cleaner.
Removing all adhesive residue.
Allow the area to dry completely before installing
the new safety sign (decal).
Position the safety sign (decal) in the correct
location.
Remove a small portion of the backing paper on
the safety sign (decal).
Press on the safety sign (decal) where the backing
paper has been removed.
Slowly remove the remaining backing paper,
pressing on the safety sign (decal) as the backing
paper is removed.
Using the backing paper, pressing firmly, move the
backing paper over the entire safety sign (decal)
area.
NOTE: Small air pockets can be pierced with a pin
and smoothed out using the piece of the
backing paper.
IMPORTANT
When replacing safety signs (decals), the
temperature must be above 10° C (50° F).
Storage And Return To Service
Storage
Sometimes it may be necessary to store the
equipment for an extended period of time. Below
is a list of items to perform before storage.
Thoroughly clean the equipment.
Inspect the hitch and all welds on the equipment
for wear and damage. Check for loose hardware,
missing guards, or damaged parts.
Check for damaged or missing safety signs (decals).
Replace if necessary.
Replace worn or damaged parts. Touch up all paint
nicks and scratches to prevent rusting.
Place the equipment in a dry protected shelter.
NOTE: If a dry protected shelter is not available,
cover with a waterproof tarp and tie down
securely.
Place the equipment flat on the ground. Place
planks under support stand if required.
Return To Service
After the equipment has been in storage, it is
necessary to follow a list of items to return the
equipment to service.
Be sure all shields and guards are in place.
Connect to a tractor and operate equipment, verify
all functions operate correctly.
IMPORTANT
DO NOT permit children to play on or around the
stored machine.
To Next Page
Loading...
