Maintenance - RT10
40
Service Schedule Chart
Maintenance work must be done at regular intervals. Failure to do so will result in excessive wear and
early failures. The service schedule is a guide for correct maintenance of the equipment.
# DESCRIPTION
SERVICE PROCEDURES
CHECK CLEAN LUBE CHANGE COVER DRAIN
Daily Maintenance (every 8 hours of use)
1 PTO Cross and Bearings
2 Tines
BI-Weekly (every 20 hours)
3 PTO Telescoping Tubes
4 Shear Pin
5 PTO Quick Disconnect
6 PTO Guard Bushings
Weekly (every 50 hours of use)
7 Rotors
8
Three-Point / Pull-Type
Hitch
9 Gearbox
Annually (every 500 hours of use)
10 Gearbox (Oil)
11 Entire Machine
To Next Page
Loading...
