Fender SWITCHBOARD - Loop Mode Editor Screen; Editing Loop Order; Editing Loop Status and Position

10
LOOP MODE EDITOR SCREEN
For full editing of all LOOP MODE parameters, the LOOP MODE EDITOR displays the signal path graphic with
the same four icon types as LOOP MODE, plus two additional icons (loop order arrows and a menu icon in the
top right corner). In the LOOP MODE EDITOR, functions for the six footswitches, footswitch LEDs and symbols
are the same as in LOOP MODE.
The encoder’s rotary and press-switch functions, however, can now be used to toggle through and select
each icon, letting the user select and edit each parameter individually. The currently highlighted symbol
illuminates in blue, while the others remain gray. Press the encoder while the icon is highlighted to edit the
desired parameter. Each icon type and function is explained below.
1
B1
B2
2
3
5
4
V
LOOP MODE EDITOR
FTSW:
T
R
F. EDIT MENU
C. EDIT VOLUME
PEDAL
E. EDIT FOOTSWITCH
D. EDIT BUFFERS
B. EDIT LOOPS
A. EDIT LOOP
ORDER
A. EDIT LOOP ORDER
The rst menu option in LOOP MODE EDITOR is EDIT LOOP ORDER, which re-
organizes all ve eect loops and the volume pedal in any order. Selecting the
EDIT LOOP ORDER icon will then display a blank signal path graphic (right).
Press each loop’s footswitch in the order preferred to build a new signal path;
Footswitch FS corresponds to the internal volume pedal. As each footswitch is
pressed, its corresponding loop icon will populate the next blank slot in the signal
path, indicating that the loop is now active in that position, as illustrated below:
ENTER LOOP ORDER
V
ENTER LOOP ORDER
2
V
ENTER LOOP ORDER
5
2
V
ENTER LOOP ORDER
5
2
V
V
ENTER LOOP ORDER
5
2
V
4
V
ENTER LOOP ORDER
2
V
ENTER LOOP ORDER
5
2
V
ENTER LOOP ORDER
5
2
V
V
ENTER LOOP ORDER
5
2
V
4
V