2 Safety
2.1 General safety instructions
–
Only use the product in original status without unauthorised modifications.
–
Only use the product if it is in perfect technical condition.
–
Observe labelling on the product.
– Only use the product in an industrial environment.
–
Do not open the product in a damp environment.
–
Before carrying out assembly, installation and maintenance work: switch off the compressed air
supply and secure it against being switched on again.
– After the compressed air supply is switched on, compressed air may be present directly at the
pneumatic working ports.
Return to Festo
Hazardous substances can endanger the health and safety of personnel and cause damage to the
environment. To prevent hazards, the product should only be returned upon explicit request by Festo.
–
Consult your regional Festo contact.
–
Complete the declaration of contamination and attach it to the outside of the packaging.
– Comply with all legal requirements for the handling of hazardous substances and the transport of
dangerous goods.
2.2
Intended use
The positioner is intended for positioning pneumatic drives.
The positioner is intended for use in an industrial environment.
The product is suitable for attachment to single-acting or double-acting semi-rotary drives or linear
drives.
The product is suitable for attachment to drives with a mechanical interface in accordance with
VDI/VDE 3845-1 (IEC 60534-6-2) or VDI/VDE 3847-2.
2.3 Training of qualified personnel
Work on the product may only be carried out by qualified personnel who can evaluate the work and
detect dangers. The qualified personnel have skills and experience in dealing with electropneumatic
(open-loop) control technology.
3 Additional information
– Contact the regional Festo contact if you have technical problems
è
www.festo.com.
– Accessories
è
www.festo.com/catalogue.
To Next Page
Loading...
