Festo CPX-FB32 - Commissioning; 2.2 Bus Configuration; Addressing; Address Assignment after Extension;Conversion

2. Commissioning
2-2
Festo P.BE-CPX-FB32-EN en 1111a
Ta b l e o f c o n t e n t s
2. Commissioning 2-1................................................
2.1 Addressing 2-3....................................................
2.1.1 Ascertaining the address range 2-4............................
2.1.2 Address assignment of the CPX terminal 2- 10.....................
2.1.3 Address assignment after extension/conversion 2-17..............
2.2 Bus configuration 2-20...............................................
2.2.1 Registering station properties in the configuration program 2-20.....
2.2.2 Overview of configuration on the EtherNet/IP 2-23.................
2.2.3 Set up a listen-o nl y connection 2-24............................
2.2.4 Configuration with RSLogix5000 2-25............................
2.3 Parameterisation 2-29...............................................
2.3.1 Methods of parameterisation 2-31..............................
2.3.2 Parameterisation via Configuration Assembly (method 1) 2-32.......
2.3.3 Parameterisation via software (method 2a) 2-36...................
2.3.4 Parameterisation with the Handheld (method 2b) 2-36.............
2.3.5 Parameterisation via the PLC user program (method 3) 2-37.........
2.3.6 Parameterisation with EDS files (method 4) 2-38..................
2.4 Notes on parameters for Idle mode and Fault mode 2-39...................
2.5 Check list for commissioning the CPX terminal with FB32 2-40...............