1. Installation
1-15
Festo P.BE-CPX-FB32-EN en 1111a
1.3.3 Setting the IP address
For setting th e IP address, CPX-FB32 four options are
avail able to you.
Note
When changes are made to the network settings of the
CPX-FB32, the Modify LED “M” flashes yellow:
• In this case, restart the CPX-FB32 with Power OFF/ON.
Dynamic addressing via BOOTP/DHCP
Factory setting In the factory setting, all switch elements of the DIL
switch 3 are set to OFF and BOOTP/DHCP is activ ated in the
CPX-FB32. The dynamic addressing via BOOTP/DHCP is then
set (see Tab. 1/4).
Fo r dynamic addressing, a BOOTP/DHCP server must be
located in the network.
If you wish to change from another type of addressing back to
dynamic addressing:
1. Set all switch elements of DIL switch 3 to OFF
(see Tab. 1/4).
2. Activate DHCP w i th the Handheld (CPX-MMI) or the
program “BOOTP-DHCP Server” from Rockwell
Automation.
Use network settings stored in the CPX-FB32
The CPX-FB32 offers the option to save the network settings
in a non-volatile memory. DHCP/BOOTP is thereby
deactivated.
1. If necessary, set all switch elements of the DIL switch to
OFF (see Tab. 1/4).
To Next Page
