2. Commissioning
2-18
Festo P.BE-CPX-FB32-EN en 1111a
Example terminal 3
modified
The next diagram shows with terminal 3 as an example
(see Fig. 2/3) the effects of modifications to the address
assignment.
The following has been changed:
– The status bits have been deactivated.
– In the case of module no. 1 an 8-input module has been
replaced by a 16-input module.
– The pneumatic interface has been set to 16 O in order to
reserve addresses for an extension to the pneumatics.
12
16DI 8DI 4DO 8DI 2AO
3
8DO
16 O
Module no.: 0 1 2 3 4 5 6
1
Modified status bits deactivated
2
Modified: 8DI module replaced by
16DI module
3
Modified: Pneumatic interface
(set with DIL switch to 1 ... 16 valve
coils)
Fig. 2/4: Example terminal 3 after extensio n/modification(compare with Fig. 2/3)
To Next Page
