Contents and general instructions
IV
Festo P.BE-CPX-FB32-EN en 1111a
2.3 Parameterisation 2-29...............................................
2.3.1 Methods of parameterisation 2-31..............................
2.3.2 Parameterisation via Configuration Assembly (method 1) 2-32.......
2.3.3 Parameterisation via software (method 2a) 2-36...................
2.3.4 Parameterisation with the Handheld (method 2b) 2-36.............
2.3.5 Parameterisation via the PLC user program (method 3) 2-37.........
2.3.6 Parameterisation with EDS files (method 4) 2-38..................
2.4 Notes on parameters for Idle mode and Fault mode 2-39...................
2.5 Check list for commissioning the CPX terminal with FB32 2-40...............
3. Diagnostics 3-1...................................................
3.1 Overview of diagnostics options 3-3...................................
3.2 Diagnostics via L EDs 3-5............................................
3.2.1 CPX-specific L EDs 3-7.......................................
3.3 Diagnostics via status bits 3-14........................................
3.4 Diagnosis via I/O diagnostic interface 3-15..............................
3.5 Diagnosis via EtherNet/IP 3-16........................................
3.6 Error handling 3-19..................................................
To Next Page
Loading...
