Festo CPX-FB36 - Parameterisation Via Configuration Data; Parameterisation with the Control Device CPX-MMI; Parameterisation in the PLC User Program

3. Commissioning
3-26
Festo CPX-FB36-EN en 1611a English
Note
The last parameterisation transferred in the CPX terminal is
always valid.
3.2.3 Parameterisation via configuration data
Parameterisation via configuration data (Configuration As
sembly) corresponds to the method for configuration with
CPX-FMT and transfer of all parameters to the “Studio 5000”
software (è section 3.1.3 Configuration with CPX-FMT).
3.2.4 Parameterisation with the control device CPX-MMI
The operator unit CPX-MMI offers menu-driven access to the
parameterisation. It does not require any additional configur
ation software.
Information about using the operator unit can be found in the
corresponding description.
3.2.5 Parameterisation in the PLC user program
The program-controlled access to parameters is effected via
Explicit Messaging. The addresses of the EtherNet/IP object
model that are required for this can be found in the appendix
(è C.1 Overview of Ethernet/IP objects).
Further information on programming this data transmission
can be found in the manual for the controller.