Festo CPX-FB36 - Parameterisation Using CPX-FMT and System Start with Saved Parameters

3. Commissioning
3-27
Festo CPX-FB36-EN en 1611a English
3.2.6 Parameterisation using CPX-FMT and system start with saved para
meters
Parameterisation corresponds to the method for configura
tion with CPX-FMT and transfer of all parameters to the “Stu
dio 5000” software (è 3.1.3).
The parameterisation of the CPX terminal is saved directly in
the bus node. To use this parameterisation, the “System
start” parameter needs to be set to “Saved parameters”
(è section 3.2.1).