Commissioning
© Festo Didactic GmbH & Co. • MPS 27
Step No.: Description Check
1 check the adjustment of mechanical components
2 check the adjustment of mechanical actuators holder
3 check the PLC-modules
4 assemble removed components (PLC-board/Control Panel)
5 cable connections (PLC-board, Control Panel, communication)
6 connect all power supplies
7 check the adjustment of sensor holders
8 check the adjustment of sensors in the holders
9 check the adjustment of sensitivity of sensor
10 tubing connections
11 connect all air-pressure supplies (careful! turn pressure down)
12 check the adjustment of the speed of pneumatic actuators
13 connect the stations together
14 check the mechanical position of hand over to the next station
15 communication connection
To Next Page
Loading...
