Commissioning
© Festo Didactic GmbH & Co. • MPS 29
Execution/Documentation
Follow the single steps of the instructor. Write down the single steps and all useful
informations into the field NOTICE.
Write down your single steps you did to proceed:
1. Press Emergency switch à reset all outputs and memories (if available, if not
press Stop-button once)
2. Check the air-pressure à = 5 bar
3. Check cable connection à plug should be locked
4. Release Emergency switch
5. Station in home position and workpiece in the feeder à Reset light is on
6. Press Start-button à light Start is on and process start
5. Station is not in home position à Reset light is off
6. Press Reset-button à movement of actuators to home position
7. Station in home position and workpiece in the feeder à Reset light is on
8. Press Start-button à light Start is on and process start
The process can be interrupted by pressing Emergency switch (if available) or Stop-
button at each time à restart with step 4 with Emergency switch or step 5 without.
How to open and download the project of the full FMS-project is shown on the
following:
To Next Page
Loading...
