Introduction
© Festo Didactic GmbH & Co. • MPS 5
Basically in Automation and Mechatronics training, the contents should cover the
following learning steps, or functions within a company:
Commissioning: Analyse a system, Installation&Commissioning
Programming: Programming single Station, Communication with other Stations
Trouble Shooting: Programming Errors, Trouble Shooting in the Process
which are covered within the following projects.
Furtheron this Teachware is based on the idea of a Flexible Manufacturing System –
FMS, this means, this station should be and is connected to other stations, called
Previous and Following Station within this Teachware.
To Next Page
Loading...
