Introduction
© Festo Didactic GmbH & Co. • MPS 7
Project overview Commissioning and Programming
Learning Step Designation Project Description Proj.. Page
Time [h]
Commissioning Analysis
Components identification:
description of the function of some components used within the stations
1.1 9 1h 30min
Commissioning Analysis
Cable connections in the system:
define and identificate all cable connections in the FMS-system
1.2 11 30min
Commissioning Analysis
In-and Output adresses of the PLC:
find out the hardwareadresses of in- and outputs in the technical docum.
1.3 13 30min
Commissioning Analysis
In-and Output adresses of the PLC expanded:
find out the hardwareadresses of in- and outputs in the technical docum.
1.4 17 1h 30min
Commissioning Commissioning
Adjustment of the Station:
check the adjustment all sensors and mechanical components
1.5 21 1h
Commissioning Commissioning
Adjustment of the Station expanded:
check the adjustment all sensors and mechanical components
1.6 23 3h
Commissioning Commissioning
Download Project and Test:
download all project-programs and test the function of the FMS-system
1.7 28 1h
Programming Programming
Hardwareconfiguration of the PLC:
define the existing Siemens S7-300 PLC-hardware with the software STEP 7
2.1 33 1h
Programming Programming
Basics in digital technology–AND:
programming of the basic function AND
2.2 46 1h 30min
Programming Programming
Basics in digital technology–OR:
programming of the basic function OR
2.3 61 1h
Programming Programming
Basics in digital technology–RS-Flip-Flop:
programming of the basic function RS-Flip-Flop
2.4 66 1h 30min
Programming Programming
Basics in digital technology–AND NOT:
programming of the basic function AND NOT
2.5 71 30min
Programming Programming
Basics in digital technology–IDENTITY:
programming of the basic function IDENTITY
2.6 74 30min
Programming Programming
Condition Call of a Program:
activate a program in OB1 by a condition of the Control Panel
2.7 76 1h
Programming Programming
Condition Call of a Program expanded:
activate a program in OB1 by a condition of the Control Panel
2.8 79 1h
Programming Programming
ON-Delay-Timer:
programming of a ON-delay timer function using the Control Panel
2.9 88 2h
Programming Programming
OFF-Delay-Timer:
programming of a OFF-delay timer function using the Control Panel
2.10 93 1h
Programming Programming
Counter down:
programming of a Counter down function using the Control Panel
2.11 95 1h 30min
Programming Programming
Programming of one flashlight:
programming a flashlight with 500 ms on/off as long as a button is pressed
2.12 97 30min
Programming Programming
Programming of a Auto/Manu-sequence:
program starts with Start-button/continues by Start or Auto/Manu-switch
2.13 99 2h
Programming Programming
Move to Starting Position:
edit a program to move to the starting (home) position automatically
2.14 101 1h 30min
Programming Programming
Move to Starting Position expanded:
advanced movement to the starting (home) position automatically
2.15 104 3h
Programming Project
Theory Basics of I/O-communication:
example of different in-/output communications using different controllers
2.16 109 1h
Programming Project
Test the I/O-communication:
edit a program to test the I/O-communication at the stations
2.17 113 1h 30min
Programming Project
Material flow through the FMS:
one alu workpiece move through the whole FMS
2.18 119 3h
To Next Page
Loading...
