5. Maintenance and conversion
5−3
Festo P.BE−VTSA−44−EN en 0509NH
Contents of this chapter This chapter explains how to fit and remove the following
components for maintenance work and conversion:
On valve locations: the fitting and removal of valves, cover
plates, pressure regulator plates, throttle plates, vertical
pressure shut−off plates and vertical supply plates.
On the pneumatic supply plate: the fitting and removal of
the
exhaust plate or the exhaust cover.
The fitting and removal of the manifold bases, the pneu
matic supply plates and the right−hand end plate.
The following activities are also described:
adding pressure zones
converting the valve terminal to internal or external
pilotair.
Further information VTSA valve terminal with CPX terminal:
Information on fitting/removing components and
on the
electrical connections can be found in the CPX system
manual.
VTSA valve terminals with multipin:
Instructions on connecting the electric components can be
found in the leaflet supplied with the product.
To Next Page
Loading...
