B. Supplementary summary of components
B−9
Festo P.BE−VTSA−44−EN en 0509NH
B.2 Separating the VTSA valve terminal from the CPX terminal
The VTSA valve terminal is connected to the CPX terminal by
means of a pneumatic interface (see following diagram).
1 CPX terminal
2 Pneumatic
interface
3 VTSA valve
terminal
12 3
Fig.B/1: Pneumatic interface (CPX)
Dismantling Proceed as follows:
1. Loosen the electrical and pneumatic connections, then
remove the VTSA valve terminal from its fastening surface
(see chapter 5, Dismantling the VTSA valve terminal").
2. Loosen the fastening screws between the pneumatic inter
face and the manifold block or pneumatic supply plate of
the VTDSA valve terminal in the
sequence 1, 3, 4, 2
(see Fig.B/2).
3. Then loosen the fastening screws.
To Next Page
Loading...
