Fiat SCUDO - Engine Compartment

190
Practical information
or in certain moving components - risk of
strangulation and serious injury!
Electric motor
Take care with objects or clothing that
could be caught in the blades of the cooling
fan or in certain moving components - risk of
strangulation and serious injury!
Before carrying out any work under the
bonnet, you must switch o󰀨 the ignition, check
that the READY indicator lamp is o󰀨 on the
instrument panel and disconnect the nozzle
from the charging connector if it is connected.
The location of the interior bonnet
release lever prevents the bonnet being
opened when the left-hand front door is
closed.
When the engine is hot, handle the
exterior safety catch and the bonnet stay
with care (risk of burns), using the protected
area.
When the bonnet is open, take care not to
damage the safety catch.
Do not open the bonnet under very windy
conditions.
Cooling of the engine when stopped
The engine cooling fan may start after
the engine has been switched o󰀨.
Take care with objects or clothing that
could be caught in the blades of the fan!
Opening
► Open the door.
► Pull the release lever 1, located at the bottom
of the door frame, towards you.
► Tilt the safety catch 2 upwards, then raise the
bonnet.
► Unclip the stay 3 from its housing and place it
in the support slot to hold the bonnet open.
Closing
► Hold the bonnet and pull out the stay from the
support slot.
► Clip the stay in its housing.
► Lower the bonnet and release it near the end
of its travel.
► Pull on the bonnet to check that it is locked
correctly.
Because of the presence of electrical
equipment under the bonnet, it is strongly
recommended that exposure to water (rain,
washing, etc.) be limited.
Engine compartment
The engine shown here is an example for
illustrative purposes only.
The locations of the following components may
vary:
– Air lter.
– Engine oil dipstick.
– Engine oil ller cap.
– Priming pump.
Fiat.K0-Fiat-VP.2021.01.en-GB.indb 190 14/02/2022 15:33:47