Fiat SCUDO - Seating Area Fittings; High Load Retaining Net

72
Ease of use and comfort
Seating area ttings
High load retaining net
This allows the use of the entire loading capacity,
up to the roof:
– behind the front seats in row 1, when the rear
seats (and bench seats) in rows 2 and 3 are
folded or removed,
– behind the rear seats (and bench seats) in row
2, when the rear seats (and bench seats) in row
3 are folded or removed.
Upper xings
► Unclip the anchorage cover in the roof on
each side.
Lower xings (behind row 1)
If your vehicle has xed one-piece bench seats
or seats and bench seats:
► On each side in row 2, insert the xings in the
oor anchorages (as shown above).
If your vehicle has seats and bench seats or
individual seats on rails:
► On each side in row 2, insert the xings in the
oor anchorages then turn them a quarter turn to
lock them in place (as shown above).
Place them as close as possible to the end of
the rail.
Lower xings (behind row 2)
► Use the stowing rings.
Fit the net
Unclip the upper xing covers and secure the
lower xings (as previously described).
► Fold (table position) the seats and bench
seats in rows 2 and 3 (according to equipment).
► Close the rear heating and air conditioning
vents (depending on the equipment you have).
► Unroll the high load retaining net.
► Position the net upper xings in the
corresponding anchorages in the roof (rst one
side, then the other).
► Fully extend the straps.
► On each side, attach the bottom xings of the
net to the lower anchorages (behind row 1) or in
the stowing rings (behind row 2).
► Tension the straps to extend the net.
► Check that the net is attached securely and
properly extended.
Fiat.K0-Fiat-VP.2021.01.en-GB.indb 72 14/02/2022 15:33:17