Fiat SCUDO - Accessing the Spare Wheel

220
In the event of a breakdown
Accessing the spare wheel
► Access to the spare wheel is from the rear.
► Depending on version, open the side-hinged
doors or the tailgate.
To avoid any unwanted opening of the
electric side door(s), deactivate the
Hands-Free Tailgate Access function in the
vehicle conguration menu.
For more information on the Hands-free
sliding side door, refer to the corresponding
section.
► If the vehicle is tted with a towbar, raise
the rear of the vehicle using the jack (must be
at jacking point B) to allow su󰀩cient space to
remove the spare wheel.
Remove the spare wheel from the
carrier
► Access the carrier bolt, located on the rear
door sill.
► Slacken the bolt using the wheelbrace (about
14 turns) until the carrier is low enough to allow
the carrier hook to be disengaged.
► Release the carrier from the hook, take the
spare wheel and place it next to the wheel to be
changed.
Ret the spare wheel in the carrier
► Position the wheel facing the carrier.
► Progressively return the wheel to the carrier
by pushing alternately at the left and right until it
is clear of the hook xing area.
► Engage the carrier on the hook, then tighten
the bolt using the wheelbrace until the bolt is fully
tightened.
Tyre in the carrier
You can change the size of the tyre on the spare
wheel by following the instructions below.
Fiat.K0-Fiat-VP.2021.01.en-GB.indb 220 14/02/2022 15:33:56