Fiat SCUDO - Switching off

136
Driving
the "START/STOP" button to assist unlocking
of the steering column. A message is
displayed.
Switching o󰀨
With the conventional key/With the
remote control key
► Immobilise the vehicle.
► Turn the key all the way to position 1 (Stop)
and remove it from the ignition.
► To lock the steering column, turn the steering
wheel until it locks.
To facilitate unlocking of the steering
column, it is recommended that the
wheels be returned to the straight ahead
position before switching o󰀨 the engine.
► Check that the parking brake is correctly
applied, particularly on sloping ground.
Never switch o󰀨 the ignition before the
complete immobilisation of the vehicle.
With the engine o󰀨, the braking and steering
assistance systems are also turned o󰀨: risk of
loss of control of the vehicle.
As a safety measure, never leave the
vehicle without taking the remote control
with you, even for a short time.
Avoid attaching heavy objects to the key
or the remote control, which would weigh
down on its blade in the ignition switch and
could cause a malfunction.
Key left in the ignition
When opening the driver's door, an alert
message is displayed, accompanied by
an audible signal, to remind you that the key
is still in the ignition switch at position 1
(Stop).
If the key has been left in the ignition switch
at position 2 (Ignition on), the ignition will be
switched o󰀨 automatically after one hour.
To switch the ignition back on, turn the key
to position 1 (Stop), then back to position 2
(Ignition on).
With Keyless Entry and Start
► Immobilise the vehicle.
► With the remote control in the recognition
zone, press the "START/STOP" button.
The engine stops and the steering column locks.
If the vehicle is not immobilised, the
engine will not stop.
To avoid any risk of jamming the pedals:
– only use mats which are suited to the
xings already present in the vehicle; these
xings must be used,
– never place one mat on top of another.
The use of mats not approved by Fiat may
interfere with access to the pedals and hinder
the operation of the cruise control / speed
limiter.
The mats approved by Fiat have two xings
located below the seat.
Starting/Switching o󰀨 the
electric motor
Starting
The drive selector must be in mode P.
► If using a conventional or remote control
key, depress the brake pedal and turn the key
to position 3 until the motor starts, without
depressing the accelerator. As soon as the motor
starts, release the key so it returns to position 2.
► If using Keyless Entry and Start, depress the
brake pedal and briey press the "START/STOP"
button.
► Keep your foot on the brake pedal until the
READY indicator lamp comes on and an audible
signal is emitted, indicating that the vehicle is
ready to drive.
► With your foot on the brake, select mode D
or R.
► Release the brake pedal, then accelerate.
On starting, the instrument panel lights up
and the power indicator needle performs one
sweep then moves to the "neutral" position. The
Fiat.K0-Fiat-VP.2021.01.en-GB.indb 136 14/02/2022 15:33:33