Fiat SCUDO - Triggering of the Alarm

45
Access
2
Deactivation
► Press the remote control unlocking
button.
or
► Unlock the vehicle with the Keyless Entry and
Start system.
The monitoring system is deactivated: the
indicator lamp in the button goes o󰀨 and the
direction indicators ash for about 2 seconds.
If the vehicle automatically locks itself
again (as happens if a door or the boot is
not opened within 30 seconds of unlocking),
the monitoring system is automatically
reactivated.
Triggering of the alarm
This is indicated by sounding of the siren
and ashing of the direction indicators for 30
seconds.
The monitoring functions remain active until
the alarm has been triggered ten times in
succession.
When the vehicle is unlocked, rapid ashing of
the indicator lamp in the button indicates that the
alarm was triggered during your absence. When
the ignition is switched on, this ashing stops
immediately.
Locking the vehicle
with exterior perimeter
monitoring only
Deactivate the interior volumetric monitoring to
avoid the unwanted triggering of the alarm, in
certain cases such as:
– Slightly open window.
– Washing the vehicle.
– Changing a wheel.
– Towing the vehicle.
– Transport on a ship or ferry.
Deactivating interior volumetric
monitoring
► Switch o󰀨 the ignition and within 10 seconds
press the alarm button until the indicator lamp is
on xed.
► Exit the vehicle.
► Immediately lock the vehicle using the remote
control or the "Keyless Entry and Start" system.
Only exterior perimeter monitoring is activated;
the red indicator lamp in the button ashes every
second.
To take e󰀨ect, this deactivation must be
performed whenever the ignition is switched
o󰀨.
Reactivating interior volumetric
monitoring
► Deactivate exterior perimeter monitoring by
unlocking the vehicle using the remote control or
the "Keyless Entry and Start" system.
The indicator lamp in the button goes o󰀨.
► Reactivate the full alarm system by locking
the vehicle using the remote control or the
"Keyless Entry and Start" system.
The red indicator lamp in the button once again
ashes every second.
Locking the vehicle without
activating the alarm
► Lock or deadlock the vehicle using the key
(integral to the remote control) in the driver's
door lock.
Failure of the remote control
To deactivate the monitoring functions:
► unlock the vehicle using the key (integral to
the remote control) in the driver's door lock,
► Open the door; this sets o󰀨 the alarm.
► Upon switching on the ignition the alarm
stops. The button indicator lamp goes o󰀨.
Malfunction
When the ignition is switched on, the xed
lighting of the red indicator lamp in the button
indicates a system malfunction.
Have it checked by a Fiat Dealership or a
qualied workshop.
Fiat.K0-Fiat-VP.2021.01.en-GB.indb 45 14/02/2022 15:33:10