Fiat SCUDO - Spare Wheel

219
In the event of a breakdown
8
► Turn the pipe assembly 2 to the left until it
comes into contact with the unit.
► Disconnect the connector 1 from the cartridge
by turning it a quarter turn anti-clockwise.
► Pull the pipe assembly 2 out slightly, then
disconnect the connector 3 from the air intake
pipe by turning it a quarter turn anti-clockwise.
► Remove the pipe assembly 2.
► Hold the compressor up vertically.
► Unscrew the cartridge 4 from the bottom.
To t the new cartridge and new pipe, carry out
these operations in reverse order.
Beware of uid discharge.
The expiry date of the uid is indicated
on the cartridge.
The sealant cartridge is designed for single
use; it must be replaced even if only partly
used.
After use, do not discard the cartridge in
standard waste, take it to a Fiat Dealership or
an authorised waste disposal site.
Do not forget to obtain a new cartridge,
available from a Fiat Dealership or a qualied
workshop.
Spare wheel
Access to the tools
The tools are stowed in a tool box.
For more information on the Tool box,
refer to the corresponding section.
List of tools
1. Wheelbrace.
Used to remove the wheel bolts and raise/
lower the jack.
2. Jack.
Used to raise the vehicle.
3. Wheel bolt cover/wheel trim removal tool.
Depending on the vehicle's equipment, this is
used to remove the wheel bolt covers on alloy
wheels or the wheel trim on steel wheels.
4. Socket for "anti-theft" wheel bolts.
Used to adapt the wheelbrace to the special
"anti-theft" bolts.
5. Towing eye.
For more information on Towing, please
refer to the corresponding section.
These tools are specic to the vehicle
and may vary according to the level of
equipment.
Do not use them for any other purpose.
The jack must only be used to change a
wheel with a damaged or punctured tyre.
Do not use any jack other than the one
supplied with the vehicle.
If the vehicle does not have its original jack,
contact a Fiat Dealership or a qualied
workshop to obtain the one that was intended
by the manufacturer.
The jack meets European standards, as
dened in the Machinery Directive 2006/42/
CE.
The jack does not require any maintenance.
Fiat.K0-Fiat-VP.2021.01.en-GB.indb 219 14/02/2022 15:33:56