Fiat SCUDO - Manual Parking Brake; Electric Parking Brake; Indicator Lamp

138
Driving
With an electric motor, this mode remains
active for about 10 minutes after the
vehicle is locked.
Manual parking brake
Application
► With your foot on the brake pedal, pull
the parking brake lever up to immobilise your
vehicle.
Release on level ground
► With your foot on the brake pedal, pull the
parking brake lever up gently, press the release
button, then lower the lever fully.
When the vehicle is being driven, this
warning lamp coming on, accompanied
by an audible signal and a message, indicates
that the parking brake is still applied or has not
been fully released.
When parking on a slope or on a steep
slope with a loaded vehicle, turn the
wheels against the kerb then apply the
parking brake.
Pressing the brake pedal facilitates the
application and release of the manual
parking brake.
With a manual gearbox, engage a gear
and then switch o󰀨 the ignition.
With an automatic gearbox, place the
gear selector in position P, then switch
o󰀨 the ignition.
Electric parking brake
In automatic mode, this system applies the
parking brake when the engine is switched o󰀨
and releases it when the vehicle moves o󰀨.
At any time, with the engine running:
► To apply the parking brake, briey pull the
control.
► To release it, briey push the control while
pressing the brake pedal.
Automatic mode is activated by default.
This automatic operation can be deactivated in
certain situations.
Indicator lamp
This indicator lamp comes on both on the
instrument panel and on the control to
conrm that the parking brake has been applied,
accompanied by display of the message
"Parking brake applied".
The indicator lamp goes out to conrm the
release of the parking brake, accompanied by
the display of the message "Parking brake
released".
The indicator lamp ashes in response to a
manual request to apply or release the brake.
In the event of a battery failure, the
electric parking brake will not operate.
As a safety measure, with a manual gearbox,
if the parking brake is not applied, immobilise
the vehicle by engaging a gear.
As a safety measure, with an automatic
gearbox or drive selector, if the parking brake
is not applied, immobilise the vehicle by
placing the supplied chock against one of the
wheels.
Contact a Fiat Dealership or a qualied
workshop.
Fiat.K0-Fiat-VP.2021.01.en-GB.indb 138 14/02/2022 15:33:34