226
In the event of a breakdown
For vehicles with interior trim, contact a
Fiat Dealership or a qualied workshop
to have the work done.
► Identify the defective lamp and then,
depending on the version, open the rear doors or
the tailgate.
► With side-hinged doors, unscrew the 2 xing
screws from the outside.
► With the tailgate, unclip the plastic trim from
the outside and then tilt it outwards to remove it.
Then unscrew the 2 xing screws.
► From the inside, and depending on the
version, remove the ventilation grille.
► While holding the lamp in place, press the
clip on the inside then carefully remove the lamp.
► Disconnect the electrical connector.
► Spread the 3 lugs slightly, then extract the
bulb holder.
► Remove the faulty bulb by pressing lightly on
it, then turning it a quarter turn clockwise.
► Replace the bulb.
Third brake lamp (W5W - 5W)
► Depending on version, open the rear left-
hand door or tailgate.
► With side-hinged doors, remove the plastic
cover with the aid of a screwdriver.
► With a tailgate, unclip the trim at each end,
rotating it from bottom to top, then unclip the
centre clips to remove it.
► Using a screwdriver through the aperture,
push the lamp towards the outside.
► Disconnect the electrical connector and then
remove the lamp.
► Unscrew the bulb holder a quarter turn anti-
clockwise and replace the faulty bulb.
To ret, press on the lamp to clip it into place.
Fiat.K0-Fiat-VP.2021.01.en-GB.indb 226 14/02/2022 15:33:57
To Next Page
Loading...
