SERVICING THE E100 15
Shutting down the E100
Before you inspect or service the E100, you must shut it down. Obtain permission from the
network administrator to temporarily shut down the E100.
If the E100 is not responding, and it is not possible to shut it down from the copier
touch panel, you can force the E100 to shut down. Only force the E100 to shut down as a last
resort, after an unsuccessful attempt at a normal shutdown.
TO SHUT DOWN THE E100
1. Verify that the E100 is not in use.
2. On the copier touch panel, press the Application button.
3. Press Fiery.
4. Press the Info tab.
5. On the Server tab, press Reboot Server.
6. Press Shut Down System.
TO FORCE THE E100 TO SHUT DOWN
• On the E100, press the power button until the green light turns off.
To Next Page
Loading...