Fiery E100 - Clearing the CMOS

To Next Page

To Previous Page

COMPONENTS 57

Clearing the CMOS

Clear the CMOS after installing a new motherboard, CPU, DIMM, or HDD to ensure

compatibility between the new component and the settings stored in the BIOS.

TO CLEAR THE CMOS

1. Shut down and open the E100 (see page 14).

Make sure to remove the AC power cable from the power outlet before opening the E100 and

clearing the CMOS.

2. Remove the battery (see page 34).

3. Wait two minutes to allow the motherboard electrical components to fully discharge.

4. Reinstall the battery (see page 34).

5. Reassemble the E100 and verify its functionality (see page 18).

6. Reset date and time in Setup (see Configuration and Setup, which is part of the user

documentation set).