SYSTEM SOFTWARE 62
Installing system software through a USB flash drive
To install system software with a USB flash drive attached to the E100, you need the
following items:
• USB Prep Tool CD (included in the E100 service kit)
• CD or DVD containing the service software to be loaded (included in the E100 service
kit)
• USB 2.0 flash drive (not provided). If the drive has a write-protection feature, make sure
that write-protection is switched off. The drive must have a minimum capacity of 5GB.
Not all USB 2.0 flash drives are validated for use with the E100. If the drive that you are
using does not work, try another brand.
•Any PC (not provided) with:
– Windows Vista (32- or 64-bit), or Windows XP with Service Pack 2 or later
– CD or DVD drive, built-in or attached
– Support for USB 2.0
(USB 1.1 may work, but it will be very slow.)
– 256MB of available memory
To Next Page
Loading...