SYSTEM SOFTWARE 61
13. On the PC, remove the System Software DVD.
14. Do the following to return the E100 to normal mode:
• On the E100, press and hold the power button for 5 seconds.
The E100 powers off.
• On the E100, set the service switches to normal mode (move the service switches down to
the OFF position).
For more information, see “The E100 front panel includes the LED display and service
switches.” on page 27.
• On the E100, disconnect the crossover cable.
•Reconnect all cables to the E100.
– Connect the copier interface cable from the E100 to the copier.
– Connect the network switch (Ethernet) cable from the E100 to the network.
– Connect the copier (Ethernet) cable from the E100 to the copier.
– Connect the power cable from the E100 to a power outlet.
For more information, see “Checking the network connection” on page 20.
• On the E100, with the power switch is in the OFF (|) position, press the power button
once.
The E100 powers on. Wait for
00 to display on the LED display.
15. If you reinstalled system software (same version), do the following:
• Restore the system configuration.
For more information, see “Restoring the system configuration” on page 68.
• Reinstall previously installed software patches.
For more information, see “Installing software patches” on page 69.
• Ask the network administrator to reinstall customer-installed fonts and FreeForm masters
archived earlier.
16. Reconnect all dongles and devices that you removed earlier.
To Next Page
Loading...