CHECKING THE NETWORK CONNECTION 21
TO CONNECT A TWISTED PAIR CABLE TO THE E100
1. Shut down the E100 (see page 15).
2. Connect the network cable to the E100 copier (Ethernet) port.
3. Start the E100 (see page 16).
4. Configure Setup options.
The site administrator is responsible for configuring Setup according to the network and user
environment. Default settings in Setup may be adequate, although they may not be optimal
for the user’s environment. For Setup information, refer the site administrator to
Configuration and Setup, which is part of the user documentation set.
5. After configuring Setup options, verify the network connection.
After the E100 reaches Idle, it should be available on the network.
The site administrator should perform any additional Network Setup, verify the network
connection, verify that the E100 appears in the list of printers, and print a few test documents
from a networked computer that will use the E100. For more information, see
Configuration and Setup.
To Next Page
Loading...