2.0 SYSTEM OVERVIEW
UL S2203 Cheetah Xi 50 Installation Manual 2-5
FM P/N: 06-369 Rev 6, 09/2015
Exhibit 2-3: MINIMUM SYSTEM CONFIGURATIONS – CONT.
This table indicates the minimum components needed to meet the intended
applications.
Y = Yes
N = No
O = Optional
Protected Premises
(Local)
Central Station (PPU)
Station (PPU)
Releasing Service
UL Listed
FM Approved
63-1058 Photoelectric Detector, Isolator Version O O O O Y Y
Ionization Detector, Isolator Version
Combination Photo/135°F Heat Detector
Combination Photo/135°F Heat Detector, Isolator Version
Heat Detector, 135°F-190°F (57-88°C) FT/RR
Heat Detector, 135°F-190°F (57-88°C) FT/RR, Isolator
63-1054 (EBF) Detector Base, 6-inch O O O O Y Y
Detector Base, 6-inch, Isolator Version
63-1061 (EBI) Detector Base, 4-inch, Isolator Version O O O O Y Y
MMM – Mini Monitor Module
MMM – Mini Monitor Module, Isolator Version
MM – Monitor Module 4-inch
MM – Monitor Module 4-inch, Isolator Version
20-1063 APS – Addressable Pull Station O O O O Y Y
APS – Addressable Pull Station, Isolator Version
RCM – Releasing Control Module
55-053 RCM – Releasing Control Module, Isolator Version O O O O Y Y
SCM – Supervised Control Module
SCM – Supervised Control Module, Isolator Version
Series Solenoid Diode/Resistor
RM – Relay Module, Isolator Version
63-1057 Photo Duct Detector O O O O Y Y
Photo Duct Detector, Isolator Version
Duct Detector Housing (isolator base)
68-140 FAAST Aspirating Smoke Detector O O O O Y Y
FAAST XT Aspirating Smoke Detector
1. Module is required to monitor sprinkler system components (e.g., Waterflow, Tamper, Low Air, etc.).