3.0 SYSTEM COMPONENTS
UL S2203 Cheetah Xi 50 Installation Manual 3-11
FM P/N: 06-369 Rev 6, 09/2015
3.5.6 INTELLIGENT GRAPHIC ANNUNCIATOR
The LED Graphic (See Exhibit 3-19) is a custom made
graphic display that provides a specific building layout
pictorial with the actual fire alarm devices indicated with a
color status LED (red, green, yellow or orange). When an
event occurs, the intelligent data will be transferred via the
RS485 output to the graphic and the specific device or zone
LED will light as programmed.
Refer to Fike document 06-231 for more information.
3.5.7 TWENTY ZONE REMOTE ANNUNCIATOR, P/N 10-2667
The Twenty Zone Remote Annunciator (See Exhibit 3-20) is a
tabular based display equipped with 40 LEDs (twenty red and twenty
yellow). Each LED can be individually configured to annunciate the
status of the host control panel or an individual zone/state event.
Refer to Fike document 06-453 for more information.
3.5.8 RELAY CONTROL ASSEMBLY, P/N 10-2777
The Relay Control Assembly (See Exhibit
3-21) provides a mounting location for up
to six (6) CRM4 (P/N 10-2204) and/or
HPM4 (P/N 10-2770) relay modules. This
configuration allows up to twenty-four (24)
programmable relays to be added to the
system to provide system status
indication, control of electrical loads, or
general purpose switching.
The assembly includes the Relay Control
Card (P/N 10-2778), Bus Card (P/N 10-
2769), and Interface Cable (P/N 10-2784).
The CRM4 and HPM4 relay modules are
ordered separately.
Refer to Fike document 06-580 and 06-443 for more information.
Note: The CRM4 and HPM4 relay cards are compatible with the Relay Control Assembly only.
Exhibit 3-20: Twenty
Exhibit 3-21: Relay Control Assembly
Exhibit 3-19: LED Graphic Annunciator
To Next Page
Loading...
