4
CONTENTS
8.11 Removing the motor rotor 56
8.12 Removing the pump cap cover 56
8.13 Removing the tub 57
8.14 Removing the kickstrip 57
8.15 Removing the lower cowling 57
8.16 Removing the wiring cover 58
8.17 Removing the heater 59
8.18 Replacing the motor 60
8.19 Replacing a fill hose, drain hose or wiring harness 61
8.20 Replacing the motor controller 64
8.21 Replacing the flood sensor harness 65
8.22 Replacing the water inlet valve 65
8.23 Replacing the lid actuator 66
8.24 Replacing the lid assembly 66
8.25 Replacing the yoke assembly 67
8.26 Replacing the side rail 68
8.27 Replacing the chassis trim 68
8.28 Replacing the temp sensor 68
9 WIRING DIAGRAM 69
10 NOTES 70
To Next Page
Loading...
Need help?
General
