flamco Flamcomat - 1 General Safety Instructions; Appropriate Use; Warning Symbols in this Manual; Transportation, Storage, Unpacking

TemplateA4_v20130506
4
1. General safety instructions
The present document is a supplement to the installation and operating manual: Flamcomat, Doc.-
Nr.:00018/11-2010/eng.;FlexconM-K,MC00019/01-2011/engandmustonlybeusedwiththesebasicdocuments.Thegeneral
safety instructions contained therein apply in particular, as does the information on equipment, use and function.
FurtherproductinformationcanbeobtainedfromtherespectiveFlamcobranchofce(seepage2).
Forinstallationinstructionsandfurtherdocumentationinvariouslanguages,visitwww.amcogroup.com/manuals.
1.1 Appropriate use
Level-controlledtoppingupofsystemwater(heatcarrier)withfeedwaterinheatingandcoolingwatersystems.Thisservesto
compensateforoperationallossesinthesysteminordertokeeptheminimumsystempressureabovethellingleveltrackingvalue
in compressor-controlled or pump-controlled expansion automats.
Indoingso,theSPC(controlunitonthepressuremaintenanceunit)takesoversurveillanceofthelevel-controlledpressurisationunit
and, in line with demands, controls the pump integrated in the Flamco-Fill P.
The pressurisation unit's range of applications in terms of system pressure, or Flamco-Fill P system connection pressure, is between
1and9bar(PN10).Forheatingsystems,toppingupispermissibleasperDINEN12828,orinsystemswithmax.owtemperatures
upto105°C.Fordesignoutputsabove1MW,theowner/usermayneedtohandleadditionalsafety-relatedrequirements,where
appropriate,incooperationwithanotiedbody,inaccordancewithcurrentharmonisedEuropeanstandards.Systemwaterandlling
water are separated by a free outlet as per EN 1717 and DIN 1988.
1.2 Warning symbols in this manual
Warning of hazardous electrical voltage
Failuretoobservecancausefatalinjury,reorotherdamage,
or lead to overloading of individual components and to damage, or functional impairments.
Warning in case of errors and incorrect initial conditions.
Failure to observe can lead to serious personal injury, component overload and damage, or functional impairments.
1.3 Transportation, storage, unpacking
Theequipmentisdeliveredinpackingunitsincompliancewiththecontractualspecications,orrequirementsforspecictransport
methods and climate zones. They meet the requirements of the Flamco STAG GmbH packaging guidelines as a minimum.
Inaccordancewiththeseguidelines,thepressirisationunitaresuppliedpackedatonspecialpallets.Thesepalletsaresuitable
for horizontal transportation with suitable fork-lift trucks. The forks must be set to the widest possible outer dimensions in order
to prevent the load from tipping. The goods delivered must be moved at the lowest possible setting of the lifting equipment,
perpendicular to the forks. If the packages are suitable for lifting gear, they are marked at the appropriate lifting points.
Importantnote:Transportthepackedgoodstoapositionascloseaspossibletotheenvisagedset-uplocation;makesurethereisa
level, load-bearing surface on which the goods can be deposited.
Caution: After removing the unit from the pallet and packaging, take safety precautions to avoid impact, tipping and swinging. Use
an approach that prevents uncontrolled falling, sliding or tipping over. The goods may also be temporarily stored in their packaging.
Avoid stacking more than three packaging units. Use only permitted lifting gear and safe tools, and wear the required personal
protective equipment.