12
The Flashforge Creator Max comes
pre-assembled and is almost ready to print.
All you need to do is to set the appropriate
voltage, mount the extruder set, and install
the filament. It will only take about 5-10
minutes to setup the Flashforge Creator
Max and prepare for your first 3D print!
1. Lay the extruder set on top of the extruder
seat with the two extruder fans facing the
front.
2. Secure the extruder set onto the extruder
seat with two M3x8 screws, from the
bottom up.
To Next Page
Loading...
