Wi-Fi Connection
Perform the following steps to connect your PC to the printer using a Wi-Fi® connection.
Note that printing from an SD™ card is disabled when Wi-Fi is enabled.
1. Power on the printer and your computer.
2. On the printer, select Tool > Setting > WIFI > WIFI ON.
3. Open your computer's wireless network settings and scan for available Wi-Fi® signals.
4. Open your internet browser. Type 10.10.100.254 and press the Enter key on your keyboard.
Enter the username and password to login. The default username and password are both admin.
The control panel will appear after successful login.
5. Click the WiFi Set tab on the left, then set the WiFi Work Mode to AP mode or STA mode, then click
Restart to make the changes take effect.
38
Sys status
Sys status
Sys run time 0 days 00:09:06
module MAC D8:B0:4C:D0:38:4E
module MID USR-C322
module ver 1.14.13
3DPrinter
wifi Status
wifi mode Access Point
AP IP 10.10.100.254
AP channel 6
AP ssid Flashforge Creator Max
AP secure Open
WiFi Set
Trans Set
Reload Reset
About FF
To Next Page
Loading...
