18 Settings
18.1 Dialogs and menus FLUXUS G801
2020-06-26, UMFLUXUS_G801V1-0EN
154
18.1.6 Alarm state indication
• Select on to display the alarm state during the measurement.
• Press ENTER.
18.1.7 Units of measurement
It is possible to set the units of measurement for the length, temperature, pressure, density, kinematic viscosity and sound
speed.
• Select a unit of measurement for all quantities.
• Press ENTER after each selection.
18.1.8 Settings relating to the fluid pressure
It is possible to set whether the absolute or the relative pressure is to be used:
• Select on or off.
• Press ENTER.
If on is selected, the absolute pressure p
a
will be displayed/input/transmitted.
If off is selected, the relative pressure p
g
will be displayed/input/transmitted.
p
g
= p
a
- 1.01 bar
The pressure and its unit of measurement are displayed, e.g., in the program branch Parameter. It is followed by the
selected pressure, indicated in parentheses:
a – absolute pressure
g – relative pressure
Special Funct.\...\Dialogs/Menus\SHOW RELAIS STAT
Special Funct.\...\Dialogs/Menus\Pressure absolut
Notice!Notice!
The standard pressure in the menu item Special Funct.\SYSTEM settings\Gas-Measuring\Norm/Std press.
is entered as absolute value.
Fluid pressure
1.00 bar(a)
To Next Page
Loading...
