8 Start-up of the Transmitter PIOX S70x
UMPIOX_S7V4-6-3EN, 2018-10-10 87
8.5 Language Selection
The transmitter can be operated in the languages listed below. The language can be selected with the following Hot-
Codes:
Depending on the technical data of the transmitter, some of the languages might not be implemented.
When the last digit has been entered, the main menu will be displayed in the selected language.
The selected language remains activated when the transmitter is switched off and on again. After an initialization, the de-
fault language set by the manufacturer is activated.
8.6 Operation State Indication (PIOX S709)
The operation state is indicated by 2 LEDs
8.7 Interruption of the Power Supply
As soon as the measurement begins, all current measuring parameters will be stored in a non-volatile INIT-resistant
EPROM. The measurement will be interrupted if the power supply fails. All input data will remain stored.
The interrupted measurement is continued. All selected output options are still active. The measurement will not be contin-
ued after the return of the power supply if an initialization has been performed.
Tab. 8.1: HotCodes for language selection
909031 Dutch
909033 French
909034 Spanish
909044 English
909049 German
Tab. 8.2: Operation State Indication (LED SIGNAL)
LED off transmitter offline
LED lights green signal quality of the measuring channel sufficient for a measurement
LED lights red signal quality of the measuring channel not sufficient for a measurement
Tab. 8.3: Operation state indication (LED READY)
LED off no measurement
LED lights yellow measurement
LED flashes yellow before a HotCode can be entered, key C has to be pressed
After the return of the power supply, the serial number is displayed for a few seconds.
FLEXIM FLUXUS
S70x -XXXXXXXX
To Next Page
Loading...
Need help?
General
