H A R D W A R E I N S T A L L A T I O N C H A P T E R 1
Note 1: Do not apply power to the FLEX-3000 until you are instructed to do
so.
Note 2: Retain the FLEX-3000 packaging for future use. This packaging was
specially designed for the radio to prevent damage which may occur
during shipping. If you ever need to ship your FLEX-3000 anywhere,
especially back to FlexRadio Systems, this is the preferred packaging
to use.
Location Considerations
To facilitate integrating your FLEX-3000 into your shack you may want to consider the following:
Place your FLEX-3000 in close proximity to your computer . It is best to use the shortest
FireWire cable possible to connect to your computer to minimize data errors and limit possible
RFI getting into the computer. High quality, quad-shielded FireWire cables up to 10m in length
have been used successfully with the FLEX-3000.
Ensure convenient access to the back panel . The FLEX-3000 back panel is where several of your
connections will be made. Having easy access to the back panel without moving the
transceiver is optimal while getting started.
Avoid placing the FLEX-3000 in direct sunlight . Placing the transceiver in direct sunlight will
increase the ambient temperature inside the chassis (especially while transmitting) and make
the high volume cooling fans' job more difficult.
Heed air flow requirements . Air enters from the sides and is expelled through the rear vent for
optimal cooling. Do not block these vents since doing so will reduce the cooling efficiency.
Avoid contact with liquids . Although this is usually not a problem unless you are operating
maritime mobile, accidental spills of liquids on the FLEX-3000 could result in voiding the
warranty. Placing the FLEX-3000 away from food and drinks is highly recommended.
[The rest of this page has been left blank intentionally]
2 2003-2009 FlexRadio Systems
To Next Page
Loading...
Need help?
General
