S E T U P F O R M C H A P T E R 4
General Tab
Hardware Config Sub-Tab
Figure 60: Setup Form - General Tab, Hardware Config Sub-Tab
FLEX-3000 Config
This section lists the S/N, installed Firmware version and the installed hardware boards of your radio.
Receive Only
Check this box to use only the receiver, while disabling the transmitter. When checked, MOX, TUN and
VOX will become unavailable on the Front Console and PTT (either via the MIC connector or the back
panel PTT connector) will also not function.
[The rest of this page has been left blank intentionally]
63 2003-2009 FlexRadio Systems
To Next Page
Loading...
