Using the Main Menu13
To restore default settings:
1. From the Main Menu, click
and then click Setting > Default.
2. Do one of the following:
• Check the menus you would like to reset to default settings, or click All to reset all
menus. Click Apply and OK when done.
• Check Factory Default to restore NVR settings to its out-of-box state. Click OK to
confirm. The NVR will reboot automatically.
13.3.24 Upgrading Firmware from a USB Flash Drive
The system supports automatic firmware upgrades over the network to ensure your unit is
always up-to-date. It is recommended to always use automatic upgrade unless directed to
perform a manual upgrade by technical support.
To upgrade firmware from a USB flash drive:
1. Download the firmware upgrade from www.flir.com/security/pro.
2. Extract the firmware file and copy the firmware to a blank USB flash drive.
NOTE
Do not have any folders on the USB flash drive—just the firmware file.
3. Insert the USB flash drive to a USB port on the system.
#LX400094; r.43927/43955; en-US
93
To Next Page
Loading...