FLIR DNR214 - Saving Your System Configuration to a USB Flash Drive

Using the Main Menu13
To configure other display settings:
1. From the Main Menu, click
and then click Setting > Display > Display.
2. Configure the following:
• Transparency: Adjust the menu transparency.
• Time Display: Check to show the time on the live display.
• Channel Display: Check to show the channel names on the live display.
• Image Enhance: Check for the NVR to digitally improve the video quality on the live
display. This setting does not affect recordings.
• Original Scale: Click Set next to Original Scale to set the system to show the true
aspect ratio of the cameras on the live display. This may add black bars to the top
and bottom of the image.
3. Click Apply and OK to save changes.
13.3.22 Saving Your System Configuration to a USB Flash Drive
The system allows you to save your current system configuration to a USB flash drive (not
included). This is useful if you want to backup your current settings.
NOTE
This function only saves settings created in system menus. It does not save or backup any video.
To save your system configuration to a USB flash drive:
1. Insert a USB flash drive (not included) into one of the USB ports.
#LX400094; r.43927/43955; en-US
90