Using the Main Menu13
5. (Optional) Click the Copy button to copy recording settings to other channels.
6. Click OK to save changes.
13.1.7 Configuring Audio Recording
The system supports audio recording. Audio-enabled cameras (not included) are required
to use audio recording. The MIC IN port is reserved for two-way audio.
To configure audio recording:
1. From the Main Menu, click
and select Recording > Recording.
2. Select the audio-enabled camera under Channel.
3. Check the left Audio/Video check box to enable audio recording. Check the middle
check box to enable audio streaming to remote devices (such as a smartphone).
Check the right check box to enable video streaming to remote devices.
4. Click OK to save changes.
13.1.8 Configuring Snapshot Recording Settings
The system can be set to record snapshot images when a camera detects motion. These
snapshots can be viewed through the Playback menu or can be attached to email alerts
and push notifications. The Snapshot tab in the Recording menu controls the quality and
recording parameters for each camera.
NOTE
In order to enable Snapshot recording, the following menu options must be configured:
• The Snapshot schedule must be enabled for times that you would like to save snapshots. See 13.3.16
Configuring the Snapshot Schedule, page 82.
• Snapshot recording must be enabled for motion detection in the Event menu. See 13.3.8 Configuring
Motion Detection, page 73.
#LX400094; r.43927/43955; en-US
56
To Next Page
Loading...