Using the Main Menu13
3. Configure the following:
• Mail Select: Select FLIR to use the FLIR email server to send out notifications. This
is the recommended setting.
• SMTP Server: Enter the SMTP server address.
• Port: Enter the port used by the SMTP server.
• Anonymous: Check if your server supports anonymous logins. Otherwise, leave
this unchecked.
• User: Enter the SMTP user name.
• Password: Enter the SMTP password.
• Email Schedule: Click Setup to configure time periods during which email alerts
will be sent.
• Receiver: Enter the email address that will receive alerts.
• Sender: Enter the sender’s email address.
• Subject: Enter the subject line for the email alert.
• Attachment: Check to include a jpg image attachment of the camera.
NOTE
You must enable the Snapshot option for motion detection on each camera you would to receive
attachments. For details, see 13.3.8 Configuring Motion Detection, page 73.
• Encrypt Type: Select SSL or TLS if your server uses encryption. Select None if
your server does not use encryption.
• Interval: Enter the interval between alert emails.
• Health Enable: Check to enable health check emails. Enter the interval in minutes
for health check emails.
NOTE
Health check emails will be sent periodically to ensure that the system is functioning normally.
4. Click Test to send a test email.
5. Click OK to save settings.
13.3.6 Configuring Switch Settings (Advanced)
You can configure the networking settings for the internal PoE switch.
CAUTION
It is recommended to leave this menu on the default settings. Changing the information in this menu
may disrupt the connection to the cameras.
To configure switch settings:
1. From Live View, right-click and select Main Menu.
2. Click
> Network > Switch.
3. Check Enable.
#LX400094; r.43927/43955; en-US
72
To Next Page
Loading...