Connecting PTZ Cameras to the NVR
20
2. Click the Pattern tab.
3. Under Pattern, enter the pattern you would like to configure.
4. Move the camera into the desired start position and click Begin.
5. Move the camera into the desired end position and click End.
To run a pattern:
• Under No., select the number of the pattern you would like to go to and click
.
20.2.4 Auto Scan
An auto scan automatically cycles between a left and right point.
To create a new auto scan:
1. Click
to open the PAN/TILT/ZOOM menu.
#LX400094; r.43927/43955; en-US
196
To Next Page
Loading...