Hard Drive Installation
21
The system comes with a pre-installed SATA hard drive. You can replace the hard drive
with one up to a maximum size of 8TB.
NOTE
NVR images in this section are used for illustration only.
21.1 Removing the Hard Drive
WARNING
Make sure that the power cable has been disconnected from the NVR before removing / installing
the hard drive.
1. Power off the system, and unplug all cabling from the system.
2. Turn the NVR over and remove the cover screws (4x).
3. Loosen the hard drive screws (4x), but do not remove them.
#LX400094; r.43927/43955; en-US
198
To Next Page
Loading...