Recording9
9.4 Configuring Hard Drive Overwrite
By default, the hard drive in your unit is set to overwrite automatically, meaning that the
system deletes the oldest footage when the hard drive is full to make way for new record-
ings. This is recommended, as it makes sure that your system will continue to record with-
out any input from you. You can also set the system to stop recording once the hard drive
is full.
To configure hard drive overwrite:
1. Right-click and select Main Menu. Click
> Setting > General > General.
2. Under HDD Full, select Overwrite for the system to overwrite the oldest recordings
when the hard drive is full. Or, select Stop Record for the system to stop recording
when the hard drive is full.
3. Click OK to save changes.
#LX400094; r.43927/43955; en-US
30
To Next Page
Loading...