Using the Main Menu13
4. Configure the following to customize settings for video loss events:
• Period: Click Set to configure a schedule for video loss events. It is recommended
to leave this on the default setting, so you can be alerted at any time one of your
cameras loses video.
• Show Message: Check to show a popup message on the monitor if one of your
cameras loses video.
• Send Email: Check to enable email alerts. Enabling Send Email requires you to
set up email notifications. See 13.3.5 Configuring Email Alerts, page 70) for full
instructions.
• Channels: Check to enable video recording when video loss occurs.
• PTZ Activation: Check to enable PTZ actions when video loss occurs (PTZ camera
required; not included). Click Set to select which PTZ actions will be taken by each
camera.
• Post_REC: Enter the number of seconds the system will record after video loss
occurs.
• Sequence: Check to enable a custom sequence mode when video loss occurs on
the selected channel. Then click the channels you would like to display in the cus-
tom sequence mode.
• Snapshot: Check to save a snapshot when video loss occurs.
• Buzzer: Check to enable the system buzzer when video loss occurs on the cur-
rently selected channel.
5. Click OK to save changes.
13.3.10 Configuring Tampering Settings
Allows you to set up your camera to detect video tamper, and trigger alerts.
To configure video tamper settings:
1. From the Main Menu, click
and then click Event > Motion > Tampering.
#LX400094; r.43927/43955; en-US
77
To Next Page
Loading...