Using the NVR On-Screen Display
7
1. Main Menu: Opens the Main Menu for browsing. For details on Main Menu func-
tions, see 13 Using the Main Menu, page 50
2. Collapse
3. Viewing Options: Select how many channels are shown on screen during Live
View.
4. Sequence Control: Click to start / stop sequence mode. In Sequence Mode, the
NVR automatically switches between channels every few seconds.
5. PTZ: Click to open PTZ controls.
6. Camera Setting: Click to open camera image settings.
7. Playback: Opens the Playback Menu. This allows you to search for video record-
ings saved on the NVR’s hard drive. For details on using the Playback menu, see
15.4 Playback, page 110.
8. Event: View alarms in progress. See 13.2.4 Event, page 61.
9. Channel Info: Click to access status information about connected cameras.
10. Remote Device: Manage network cameras over the network.
11. Network: Configure network settings for your system. See 13.3.1 Network, page 67.
12. HDD Manager: Manage hard drives connected to the system. See 13.3.18 Format-
ting the Hard Drive, page 85.
13. USB Manager: Click to access options for connected USB flash drives (not in-
cluded). You can backup video, logs, or system configurations and install firmware
upgrades.
14. Upgrade: Check for firmware upgrades. The system must be connected to the In-
ternet to check for or receive updates.
7.4 Using the Camera Tool bar
The Camera Tool bar lets you perform quick functions for a specific channel on the NVR.
• Hover the mouse near the top of a channel with a connected camera.
• The Camera Tool bar opens at the top of the camera’s live display:
1. Instant Playback
#LX400094; r.43927/43955; en-US
22
To Next Page
Loading...