Basic Setup
5
5.1 Step 1: Connect the Network Cameras
• Connect network cameras to the PoE Ports on the rear panel of the NVR using Cat5e
or higher grade Ethernet cable. The cameras will appear on the NVR without any addi-
tional configuration when the system starts up.
NOTE
You can also connect your network cameras to your local network for flexible installations. For details, see
5.13 Connecting Cameras to the Local Area Network (LAN), page 12.
5.2 Step 2: Connect the Mouse
• Connect the included USB mouse to one of the USB ports.
5.3 Step 3: Connect the Ethernet Cable
• Connect the included Ethernet cable to the LAN port on the rear panel of the system.
Connect the other end of the Ethernet cable to a router or switch on your network.
5.4 Step 4: Connect the Monitor
• Connect the included HDMI cable to the HDMI port, then to a TV or monitor
(recommended).
OR
• Connect a VGA cable (not included) to the VGA port, then to a monitor.
#LX400094; r.43927/43955; en-US
8
To Next Page
Loading...